Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - kai

Pages: [1]
Wish List / Re: Make automatic recalculation optional
« on: January 17, 2018, 01:00:10 PM »
Hi MagWeb,
thanks a lot for the hints!

Wish List / Make automatic recalculation optional
« on: January 15, 2018, 01:03:39 PM »
Hello all,
I am working with rather large meshes (multiple million vertices). When select the whole mesh and go into edit mode (for example for extrusion), then the mesh is recalculated with every change I do in the parameters of the dialog. This takes about 30 sec or more for each change. Thus, the use of a slider is impossible.
It would be great if there was a global setting to turn off automatic recalculation and only calculate when the dialog is closed with "Accept" (or a certain key is pressed).
Best regards

Pages: [1]