Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - eviglotti

Pages: [1]
1
Questions & Troubleshooting / Re: Smoothing/tangent mesh
« on: September 13, 2017, 03:01:52 AM »
Thank you so much, this definitely worked perfectly. I had to play with it a few times and turn on wireframe to see the result, but each iteration I could see the additions of the triangles that then got smoothed with the deform -> smooth command. There is no question my source STL file was very deficient on triangles as is the case with many models coming from CAD programs.

Thanks!

2
Questions & Troubleshooting / Smoothing/tangent mesh
« on: September 11, 2017, 07:14:38 PM »
Hello,

I have an STL object I created from OpenSCAD that is attached as a zipped STL and screenshot. It is basically just a bunch of varying height cubes and I want to take an object such as this and apply a function in meshmixer to create a smoother version, basically something that is a set of tangent curves that cover the whole thing. The end output should look like what would happen if you draped a sheet over the object or as if snow came from the sky and fell over the object making nice smooth curves/hills everywhere.

Any ideas if this can be done? I tried the deform/smooth command and no matter what settings I used it didn't come close to that type of effect.

Thanks!

Pages: [1]