Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - locweb

Pages: [1]
1
Hi, do you received the we transfer link with my files ?

2
Thanks a lot, I will prepare all my files.
Regards.

3
Thanks for your help, I tried, but the result is far to be perfect, when I make solid some holes are filled too much.
May I send you my file ?
Regards.

4
General Discussion / Help to stick and clean a multipart scanned object
« on: September 01, 2017, 02:31:06 AM »
Hi, I have scanned a body with Scannect/Kinect, but to get a good quality I have made 6 scans of differents parts.
I am not an informaticianm I am an artiste and a very big begineer.
I get errors messages vhen I try to join the differents objects together.
I waste time for a bad result.
Is somebody able to make this for me whith a compensation ?
Thanks a lot for your help.
My project is here: https://www.facebook.com/Zerno-381745965527209/

5
Questions & Troubleshooting / Re: How to fill a crack ?
« on: August 04, 2017, 10:02:20 AM »
I tried too with weld boundaries, same error message !

6
Questions & Troubleshooting / Re: How to fill a crack ?
« on: August 04, 2017, 01:39:44 AM »
Hi, I tried many options: Brige - Join and I get an error message.
I tried to smooth boundaries, same error.
Here you have a screenshot.
Thanks

7
Questions & Troubleshooting / How to fill a crack ?
« on: July 26, 2017, 02:35:41 AM »
Hi,
I scanned an object wit a kinect, and there are big cracks on the mesh.
I tried to select the sides of the crack, and maje join, but it doesn't work.
I tried to sculpt to approach the 2 sides, but there is still a visible line.
It is like if I want to connect together the two ears of the bunny.
Thanks for your help.

8
Questions & Troubleshooting / Re: Filling a hollow form
« on: July 17, 2017, 02:03:24 PM »
YESSS, it works now with your method.
Thanks a lot.

9
Questions & Troubleshooting / Re: Filling a hollow form
« on: July 14, 2017, 10:45:03 AM »
Hi, I tried to analysis, and accept the repairs.
After, I cut it in the middle and make erase et fill but it dont fill the inside structure.
I have no solution.
Regards

10
Questions & Troubleshooting / Re: Filling a hollow form
« on: July 06, 2017, 12:47:16 AM »
Hi, I tryed to do this, but it is too much heavy (106672ko).

11
Questions & Troubleshooting / Re: Filling a hollow form
« on: July 05, 2017, 10:53:23 AM »
Hi, I have a full body  form scanned with Skanect, and it is not filled inside.
I would like to fill it inside for making solid slices with openscad.
I tried to use the make solid, or the select and F function as mentioned above, but it dont work.
When I check with a plane cut, the form is empty inside.
May I have some help ?

My english is basic, I am French.

Regards.

Pages: [1]