Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Attachments - RMS

Pages: [1] 2 3 ... 5
Filename Downloads Message Posted
restrict.png 244 Re: restrict to group being too unrestictive February 09, 2016, 04:05:31 PM
FaceHuggerFixed.mix 168 Re: Help needed with a model I am working on February 09, 2016, 03:29:51 PM
grooves1.png 396 Re: making groves on top of 3D mesh. February 23, 2015, 03:20:32 PM
lannes_turret.mix 264 Re: Unable to create hole when hollowing October 17, 2014, 12:54:10 PM
honeycomb2.png 651 Re: Can I use meshmixer to add honeycomb pattern to one side of part? April 23, 2014, 05:57:47 PM
honeycomb3.png 780 Re: Can I use meshmixer to add honeycomb pattern to one side of part? April 23, 2014, 05:57:47 PM
honeycomb4.png 722 Re: Can I use meshmixer to add honeycomb pattern to one side of part? April 23, 2014, 05:57:47 PM
honeycomb5.png 662 Re: Can I use meshmixer to add honeycomb pattern to one side of part? April 23, 2014, 05:57:47 PM
cutup_1.png 1169 Re: meshmixer 2.3 April 22, 2014, 11:16:49 AM
cutup_2.png 1177 Re: meshmixer 2.3 April 22, 2014, 11:16:49 AM
Screen Shot 2014-04-20 at 9.34.05 PM.png 449 Re: Support exceed negative Y-axis. April 20, 2014, 09:36:28 PM
Screen Shot 2014-04-20 at 9.32.51 PM.png 426 Re: Support exceed negative Y-axis. April 20, 2014, 09:36:28 PM
SurfDraw1.png 1180 Re: meshmixer 2.2 March 19, 2014, 10:50:47 PM
SurfDraw2.png 1206 Re: meshmixer 2.2 March 19, 2014, 10:50:47 PM
SurfDraw3.png 1184 Re: meshmixer 2.2 March 19, 2014, 10:50:47 PM
Pages: [1] 2 3 ... 5